Figure 9. Removing The Pallet Skids And Supports – Eaton 93Pm Integrated Battery Cabinet-Small - Eaton 93pm Installation Manual

Figure 9. Removing the Pallet Skids and Supports – Eaton 93PM Integrated Battery Cabinet-Small
Rear Cabinet
Support
Cabinet
Support Bolts
(2 Places at
each corner)
10. Remove the cabinet support bolts fastening the front, rear, and side cabinet supports together and remove
the side supports (see
11. Remove the cabinet mounting bolts holding the front and rear supports to the cabinet base and remove
the supports (see
12. If installing the cabinet permanently, retain the cabinet mounting bolts; otherwise, recycle the bolts along
with the support brackets in a responsible manner.
13. Close the door and secure the latch.
14. If the leveling feet are not retracted, turn all four leveling feet until they are retracted as far into the cabinet
as possible.
NOTE The battery cabinet may be located to either the right or left of the UPS cabinet. The
recommended location is to the right of the UPS cabinet. This procedure assumes the
battery cabinet is located to the right of the UPS cabinet.
15. If line-up-and-match installation, remove the rectangular and circular knockout on the bottom and top front
side of the UPS and the IBC (see
16. The IBC is shipped set up for rear ventilation with a cover plate installed over the ventilation grill on top of
the unit (see Figure
the unit and install the plate over the rear ventilation grill (see
Left Side
Cabinet
Support
Pallet Skid
Figure 9).
Figure 9).
Figure 10).
11). If top ventilation is required, remove the screws securing the plate at the top of
Eaton 93PM Integrated Battery Cabinet-Small (IBC-S) Installation Manual 164000305—Rev 06
Cabinet
Mounting Bolts
(4 place front)
(4 places rear)
Front Cabinet
Support
Skid Mounting Bolts
(4 places front)
(4 places rear)
Jacking Bolts
(2 places front)
(2 places rear)
Floor Protectors
(2 places front)
(2 places rear)
Figure 12).
Installation
Right Side
Cabinet Support
25