Table of Contents
Advertisement
Figure 9. Removing the Pallet Skids and Supports – Eaton 93PM IBC-LW or Eaton 93PM IBC-LHW
Rear Support
Skid Mounting Bolts
(6 places left side)
(6 places right side)
Left Support
Pallet Skid
Cabinet Mounting Bolts
(4 places left side)
(4 places rright side)
CABINET MAY FALL. Do not loosen the hardware attaching the front supports to the cabinet base. The cabinet
must be lowered by the jacking bolts before the supports can be removed.
8.
Carefully and evenly lower the cabinet by turning each jacking bolt consecutively two full turns
(maximum) until the casters contact the floor and the cabinet is no longer supported by the jacking bolts.
9.
After the IBC is resting on the floor, remove the jacking bolts and floor protectors. Recycle them in a
responsible manner.
10. Remove the cabinet support bolts fastening the left, right, front, and rear supports together (see
11. Remove the cabinet mounting bolts holding the left, right, front, and rear supports to the cabinet base.
Eaton 93PM Universal Integrated Battery Cabinet (IBC-LW and IBC-LHW) Installation Manual P-164000541—Rev 04
Front Door Mounting Bolts
(4 places top)
(2 places bottom)
Front Door
Cabinet Mounting Bolts
(4 places front)
(4 places rear)
Front
Cabinet
Support
Support Bolts
(1 at each corner)
CAUTION
Installation
Right Support
Jacking Bolts
(2 places front)
(2 places rear)
Floor Protectors
(2 places front)
(2 places rear)
Figure
9).
31
Advertisement
Table of Contents
