Eaton 93pm Installation Manual page 28

Installation Plan and Unpacking
3 3 . . 3 3 I I n n s s p p e e c c t t i i n n g g a a n n d d U U n n p p a a c c k k i i n n g g t t h h e e I I B B C C
The cabinet is shipped bolted to a metal and wood pallet (see
packaging material.
NOTE
The IBC is heavy (see
may tip and cause serious injury.
1. Carefully inspect the outer packaging for evidence of damage during transit.
Do not install a damaged cabinet. Report any damage to the carrier and contact an Eaton service representative
immediately.
NOTE
2. Use a forklift or pallet jack to move the packaged cabinet to the installation site, or as close as possible,
before unpacking. If possible, move the cabinet using the pallet. Insert the forklift or pallet jack forks
between the supports on the bottom of the pallet. See
measurements.
Do not tilt the UPS cabinets more than 10° from vertical or the cabinets may tip over. Failure to follow these
instructions may result in serious injury or death.
3. Set the pallet on a firm, level surface, allowing a minimum clearance of 3m (10 ft) on each side for
removing the cabinet from the pallet.
4. Remove the protective packaging material from the cabinet and recycle in a responsible manner. Retain
the parts kit box packed at the top of the cabinet.
5. Inspect the contents for any evidence of physical damage, and compare each item with the Bill of Lading.
If damage has occurred or shortages are evident, contact an Eaton service representative immediately to
determine the extent of the damage and its impact on further installation.
NOTE
20 Eaton 93PM Integrated Battery Cabinet-Small (IBC-S) Installation Manual 164000305—Rev 06
Startup and operational checks must be performed by an authorized Eaton Customer
Service Engineer, or the warranty terms specified in
This service is offered as part of the sales contract for the UPS. Contact an Eaton service
representative in advance (usually a two-week notice is required) to reserve a preferred
startup date.
Table 1). If unpacking and unloading instructions are not closely followed, the cabinet
For the following step, verify that the forklift or pallet jack is rated to handle the weight
of the cabinet (see Table 1
While waiting for installation, protect the unpacked cabinet from moisture, dust, and
other harmful contaminants. Failure to store and protect the EBC properly may void the
warranty.
Figure 7), and covered with outer protective
Chapter 8 Warranty
WARNING
CAUTION
for cabinet weight).
Figure 6 for the IBC-L cabinet center of gravity
CAUTION
become void.