Eaton 93pm Installation Manual page 45

Hide thumbs Also See for 93pm:

Table of Contents

requirements. Refer to the applicable Eaton 93PM UPS Installation and Operation manual listed in

paragraph

1.7 For More

Secure the interface wiring to the wire tie anchors (see

10. Connect the battery detect interface wiring to the IBC battery detect interface terminals. See

termination requirements.

For a detailed view of the IBC terminal block, see

11. Connect the battery detect interface wiring to the UPS battery detect interface terminals.Refer to the

applicable Eaton 93PM UPS Installation and Operation manual listed in paragraph

1.7 For More

Information, for UPS cabinet termination requirements.

NOTE

In the following step, if the safety shield cannot be reinstalled because of misalignment,

use the leveling feet to realign the cabinet.

12. Reinstall the internal safety shield panel removed in

4.3.1 Line-Up-and-Match Power

13. Close the outside door and secure the latch.

14. Once the battery cabinets are installed and wired, return to the applicable Eaton 93PM UPS Installation and

Operation manual, listed in paragraph

Eaton 93PM Integrated Battery Cabinet-Small (IBC-S) Installation Manual 164000305—Rev 06

Information, for UPS cabinet terminal locations.

Figure

Wiring.

1.7 For More

Figure

15) using Zip ties.

20.

Step 3

of paragraph

Information, to complete the UPS wiring.

Installation

Table 8

for

Table of Contents