Eaton 93pm Installation Manual page 32

Installation
1. If not already accomplished, use a forklift or pallet jack to move the IBC to the installation area, or as close
as possible, before unloading from the pallet. Insert the forklift or pallet jack forks between the supports on
the bottom of the pallet (see
2. Open the front door by lifting the latch from the bottom and turning to the right (counterclockwise) and
swing the door open.
3. Locate the four 1/2" jacking bolts from the parts bag packed inside the front door and install them in the
threaded holes in the front and rear supports as shown in
underneath each jacking bolt, and screw the bolts down against them.
The floor protectors protect the floor from being marred by the jacking bolts.
Do not remove or loosen the cabinet mounting or cabinet support bolts until instructed.
4. Loosen, but do not remove, the skid mounting bolts holding the front and rear supports to the pallet skids
(see Figure
RISK OF INSTABILITY. Turning the jacking bolts unevenly may cause the cabinet to become unbalanced. To
prevent tipping the cabinet, raise and lower the jacking bolts evenly.
CABINET MAY TIP. Raise the IBC no more than 3 mm (1/8") above the floor (just enough to allow the removal
of the pallet skids).
5. Turn each jacking bolt consecutively, two full turns, until the pallet skids clear the floor by approximately
3 mm (1/8").
6. Remove the hardware loosened in
7. Pull the pallet skids out from under the metal angle supports without disturbing the jacking bolts. Recycle
the pallet skids and hardware in a responsible manner.
CABINET MAY FALL. Do not loosen the hardware attaching the front supports to the cabinet base. The cabinet
must be lowered by the jacking bolts before the supports can be removed.
8. Carefully and evenly lower the cabinet by turning each jacking bolt consecutively two full turns
(maximum) until the casters contact the floor and the cabinet is no longer supported by the jacking bolts.
9. After the IBC is resting on the floor, remove the jacking bolts and floor protectors. Recycle them in a
responsible manner.
24 Eaton 93PM Integrated Battery Cabinet-Small (IBC-S) Installation Manual 164000305—Rev 06
Figure 6 for the IBC cabinet center of gravity measurements).
9).
Step
Figure 9. Place a floor protector from the parts kit
WARNING
WARNING
CAUTION
4.
CAUTION