Profibus Module Setting; Update Of Profibus Labels; Writing Parameters - Mitsubishi Electric FX5-DP-M User Manual

7.3

PROFIBUS Module Setting

Start PROFIBUS Configuration Tool and configure the PROFIBUS module settings. ( Page 51 PROFIBUS Configuration
Tool)
[Navigation window]  [Parameter]  [Module Information]  [FX5-DP-M]  [PROFIBUS Module Setting]
7.4

Update of PROFIBUS Labels

This function creates and updates the structures used for global labels and module function blocks by enabling the refresh
settings.
[Navigation window]  [Parameter]  [Module Information]  [FX5-DP-M]  [PROFIBUS Module Settings] 
[PROFIBUS Configurator Tasks]  [Setup Tasks]  [Update PROFIBUS Label]
Precautions
After the "Module Parameter" screen is displayed, make sure to update the PROFIBUS labels.
7.5

Writing Parameters

Check the boxes in the "Module Parameter and the "PROFIBUS Module Setting" on the "Online Data Operation" window of
the GX Works3 before writing.
[Online]  [Write to PLC]
The parameters have different write destinations.
Checked item
Module Parameter
PROFIBUS Module Setting
For the writing parameters to the CPU module or the SD memory card of the CPU module, refer to the following.
 GX Works3 Operating Manual
The written parameters are enabled when resetting the CPU module or powering off and on the system.
The set parameters using PROFIBUS Configuration Tool can be written with the GX Works3, but cannot be
read.
7 PARAMETER SETTINGS
50
7.3 PROFIBUS Module Setting
Written parameters Write destination
Refresh Setting CPU module or the SD memory card of the CPU module
If the parameters are written to both the CPU module and the SD memory card, the operation is
PROFIBUS communications
performed according to the memory card parameter setting of the CPU module.
parameters