Mitsubishi Electric FX5-DP-M User Manual page 81

Slave I/O Test
Monitor and edit the I/O data of the DP-Slave assigned to the buffer memory of the master module.
Item Description
Slave Selects the monitor target DP-Slave.
Inputs/Outputs Selects the monitor target data.
• Inputs: Input data
• Outputs: Output data
Value format Selects the data type of the "Value".
• WORD (16 bit hex.): One word unsigned hexadecimal
• DWORD (32 bit hex.): Two word unsigned hexadecimal
• INT (16 bit decimal): One word signed decimal
• DINT (32 bit decimal): Two word signed decimal
• REAL (float number): Two words
• STRING (ASCII character): ASCII character
Byte Order Selects the byte order (big-endian or little-endian) of the "Value".
• Low byte first ('Little Endean'/Intel): The lower byte consists of the lower address
• High byte first ('Big Endean'/Motorola): The upper byte consists of the lower address
[Write] button Writes the values changed using ".F to .0" or "Value" to the buffer memory of the master module.
This button can be used while monitoring is stopped.
Addr Displays the decimal buffer memory address of the master module of the monitor target data.
Start Starts refresh of the window.
Stop Stops refresh of the window.
.F to .0 Displays each bit of the monitor target data.
When the buffer memory value is changed during monitoring, the changed value is displayed in red bold font.
To apply the changes to the buffer memory, double-click the changed value while monitoring is stopped, and click the [Write] button.
Upon applying the changes to the buffer memory of the master module, the bold font returns to the regular font.
To check the buffer memory address and the bit position, move the mouse pointer to the cell.
8 PROFIBUS Configuration Tool
8.2 "PROFIBUS Configurator Tasks" Window
8
79