Mitsubishi Electric FX5-DP-M User Manual page 91

If the following window is displayed when the settings are completed, set "Data consistency" in the module
parameters to "Enable (Use Autorefresh)". If not, the I/O data may be separated. ( Page 35 Data
Consistency Function)
The methods to change the module configuration are listed below.
Item
To add a module to the DP-Slave
To delete a module from the DP-Slave
To change the configuration order of the
module
Adding or deleting a slave module changes the buffer memory address of the I/O data of the master module.
• When the parameter is changed, review the program and the refresh settings. ( Page 86 CPU Device
Access)
• If the refresh settings are enabled, update the PROFIBUS labels again. ( Page 66 Update PROFIBUS
Label)
Description
Performs any of the following operations.
• Drag and drop the module to be added to the DP-Slave from "Available Slave Modules" to "Project Slave
Modules".
• Double-click the module to be added in "Available Slave Modules".
• Right-click the module to be added in "Available Slave Modules", and select [Add Module to Slave].
Performs any of the following operations.
• Select the module to be deleted in "Project Slave Modules", and click the [] button.
• Select the module to be deleted in "Project Slave Modules", and press the [Delete] key on the keyboard.
Performs any of the following operations.
• Drag and drop the module of which configuration order is changed in "Project Slave Modules".
• In "Project Slave Modules", select the module of which configuration order is changed, and click the [↓] button or
the [↑] button.
8 PROFIBUS Configuration Tool
8.3 "PROFIBUS Network" window
8
89