Requirements For Product Use; Target Group; Intended Use; Foreseeable Misuse - Festo EXCM-30 Instructions Manual

1

Requirements for product use

1 Requirements for product use
1.1

Target group

• Provide this documentation to the following persons:
– Design engineer
– Machine manufacturer
– Installer
– Commissioner
Only qualified specialists may carry out the mounting, installation, commissioning, maintenance and
dismantling of the product. The specialist must be competent at:
– Mounting and operation of mechatronic systems
– Installation and operation of electrical control systems
– Regulations for accident prevention and occupational safety
– Documentation and mode of operation of the product
1.2

Intended use

This product is a handling system. The handling system executes positioning tasks within machines or
automated systems with a higher-order controller.
Only use the product as follows:
– In perfect technical condition
– in its original condition, without unauthorised modifications
– within the limits of the product defined by the technical data
– In an industrial environment
Note
For damage resulting from unauthorised access or incorrect use the guarantee and
liability of the manufacturer lapses.
1.3

Foreseeable misuse

Never use the product as follows:
– With unauthorised modifications or alterations to the product
– With load limits exceeded
– without a risk assessment of the complete system
– Without a safety concept for the complete system
Festo – EXCM-30-EN – 1605b – English 5