Aligning And Mounting The Product (Adjusting Kits) - Festo EXCM-30 Instructions Manual

4 Mounting
4.3.2

Aligning and mounting the product (adjusting kits)

Attachment of the product using the adjusting kits is only intended for horizontal mount­
ing positions.
Required aids:
– Precision spirit level (accuracy at least 0.05 mm/m)
– Steel straightedge (straightness at least 0.05 mm/m)
– Inspection bases (2 units): final dimensions (height at least 24 mm, width max.
10 mm, accuracy 0.05 mm/m)
– Assembly instructions for adjusting kit (è www.festo.com/sp)
The following graphics represent as an example the design EXCM-30-...-B1-... with hori­
zontal mounting position.
1
X-axis 1
2
Transport lock
3
X-axis 2
4
Adjusting kit
5
Y-axis (traverse)
(A) Drive at X-axis area 1
(B) End cap at X-axis area 1
(B) End cap at X-axis area 2
(A) Drive at X-axis area 2
1. Remove profile covers.
2. Mount the adjusting kits according to assembly instructions (è www.festo.com/sp)
3. Make sure that the product and adjusting kits have the same temperature.
4. Position the product on the adjusting kits.
Festo – EXCM-30-EN – 1605b – English
(B)
1
(A)
5
Fig. 4.10
2
(C)
3
(D)
4
19