Festo EXCM-30 Instructions Manual page 23

4 Mounting
Checking evenness (X-axis 2)
When using 3 adjusting kits per X-axis: the X-axis must not be in contact with the middle
adjusting kit during the check for evenness.
1. Make sure that the inspection base 3 lies cor­
rectly on the guide rail 8 of X-axis 2.
2. Check the guide rail in the area of the adjust­
ing kit 2 for evenness by using a precision
spirit level 4.
è Setpoint value: š 0.1 mm/m
(è A.2 Flatness)
3. Adjust X-axis 2 using the adjusting kit.
4. Position the middle adjusting kit on X-axis 2
and tighten.
5. Mount all adjusting options at the adjusting kit
(X-axis 2) (è www.festo.com/sp).
6. Inspect the guide rail of X-axis 2 again for
compliance with the limit values for height off­
set in relation to X-axis 1 and for evenness.
è X-axis 2 is aligned.
7. Mount the profile covers.
Festo – EXCM-30-EN – 1605b – English
3
2
1
Fig. 4.15
4
23