Aligning And Mounting The Product (Profile Mounting) - Festo EXCM-30 Instructions Manual

4 Mounting
4.3.1

Aligning and mounting the product (profile mounting)

1. Make sure that the product and mounting surface have the same temperature.
2. Prepare the mounting surface (è 4.2.2 Mounting surface ).
3. Select type of mounting according to the intended mounting position.
The following graphics represent as an example the design EXCM-30-...-B1-... with hori­
zontal mounting position.
4. Attach the clamp holders of profile mountings with 2 socket head screws each to the mounting
surface (è 4.2.3 Types of mounting).
1
X-axis 1
2
Transport lock
3
X-axis 2
4
Y-axis (traverse)
5. Place product on mounting surface and align with the clamp holders of the profile mountings.
6. Remove transport lock.
Keep reusable transport locks and the corresponding screws for future use (maintenance,
dismantling).
7. Shift the Y-axis (traverse) in the direction of
the drive the stop position.
Festo – EXCM-30-EN – 1605b – English
1
4
Fig. 4.4
Fig. 4.5
2
3
17