Festo EXCM-30 Instructions Manual page 18

4 Mounting
Secure X-axis 1
8. Slide the clamp strips of profile mounting in
mounting slot and position above clamp holders.
9. Tighten the screws (tightening torque 1 Nm).
10.Ensure that the Y-axis (traverse) is in direction
of the drive in both stop positions.
Secure X-axis 2
11.Slide clamp strip of profile mounting in mount­
ing slot and position above clamp holder.
12.Tighten the screws lightly.
13.Shift the Y-axis (traverse) in the direction of
the end cap to the stop position.
14.Ensure that the Y-axis (traverse) is in direction
of the end cap in both stop positions.
15.Slide clamp strip of profile mounting in mount­
ing slot at the cap side and position above
clamp holder.
16.Tighten the screws lightly.
17.Tighten all screws of the profile mounting at­
tachments (tightening torque: 1 Nm).
18
Fig. 4.6
Fig. 4.7
Fig. 4.8
Fig. 4.9
Festo – EXCM-30-EN – 1605b – English