Adapting Cable Outlets - Festo EXCM-30 Instructions Manual

4 Mounting
Motors with a holding brake must be removed for mounting the product.
Dismantling the motor
1. Disconnect the cables 3 from the motor 2.
2. Unscrew and remove the headed pins 1.
For motor attachment underneath:
Secure motor from falling.
3. Disassemble motor 2.
Mount motor
4. Install motor 2.
5. Tighten the threaded pins 1 (tightening
torque 1.2 Nm).
6. Connect the cables 3 to the motor 2.
4.4.2

Adapting cable outlets

The position of the cable outlets is dependent on the design ordered of the product. If necessary, it can
be adapted subsequently to the installation situation.
The following representations represent an example for the design without motor brake,
motor attachment position underneath, cable outlets to the front (EXCM-30-...-ST-B1......).
The procedure applies correspondingly for deviating designs.
Festo – EXCM-30-EN – 1605b – English
1
Fig. 4.17
1
3
Fig. 4.18
1
2
3
1
2
25