Insert Bus Node - Festo CPX-FB39 Description

Terminal cpx, bus node, network protocol sercos iii

Hide thumbs Also See for CPX-FB39:

Table of Contents

Commissioning

3.6.4

Insert bus node

Please Note

Requirements for execution of the subsequent steps:

– Codesys project set up with programmable controller (PLC)

– Device description files (SDDML files) available in Codesys

(è 3.6.2 Installing device description files (SDDML files))

– Field bus inserted in project (è 3.6.3 Inserting field bus).

Procedure

1. Highlight "sercos_Master (sercos Master)"entry in the device window ("Device window").

2. Project menu ("Project") > Add device... ("Add Device...").

The "Add Device"dialog opens up.

Fig. 3.13

Please Note

Depending on the diagnostics mode, there is a choice of 3 entries:

– CPX-FB39-RIO (without diagnostic mode)

– CPX-FB39-RIO-ST (with status bits)

– CPX-FB39-RIO-STI (with diagnostic interface).

3. Highlight corresponding bus node entry.

4. Press the "Add Device"button.

Festo – P.BE-CPX-FB39-EN – 1504NH – English

Table of Contents