3
Commissioning
Setting the Sercos address
1. Highlight bus node gateway entry in the device window ("Device window").
2. Project menu ("Project") > Edit object ("Edit Object").
The corresponding device tab ("Device tab") appears in the editor window ("Editor window").
Fig. 3.15
3. Enter the correct Sercos address in the "sercos Slave"parameter tab ("Parameter tab").
Please Note
The entry for the Sercos address must match the setting of DIL switch 3 on the bus node
(è 2.4.7 Set the Sercos address).
46
Festo – P.BE-CPX-FB39-EN – 1504NH – English