Setting The Ip Address - Festo CPX-FB39 Description

2 Installation
2.5.5

Setting the IP address

Alternatively the IP address for the bus node can be set via:
– Dynamic addressing via DHCP/BOOTP
– Stored network setting.
The IP address is factory-set to 192.168.1.20.
Dynamic addressing via DHCP/BOOTP
Make sure that a DHCP/BOOTP server is located in the network.
• Alternatively activate dynamic addressing by DHCP/BOOTP via:
– Operator unit (CPX-MMI)
– Festo Maintenance Tool (CPX-FMT) software
– Sercos IDNs.
Saved network settings
The bus node CPX-FB39 offers the option of saving network settings in a non-volatile memory unit.
DHCP/BOOTP is thereby deactivated.
• Alternatively change the network settings via:
– Operator unit (CPX-MMI)
– Festo Maintenance Tool (CPX-FMT) software
– Higher-order system
– Sercos IDNs.
This activates saving of the network settings.
Festo – P.BE-CPX-FB39-EN – 1504NH – English 21