A Technical Appendix - Festo CPX-FB39 Description

A Technical appendix
A Technical appendix
A.1 Technical data
General information
General technical data
Degree of protection in accordance with
IEC 60529, completely mounted, plug connector
in accordance with accessories plugged in or
equipped with cover cap
Protection against electric shock
(Protection against direct and indirect contact in
accordance with IEC 60204-1)
Module code (CPX-specific)
Remote I/O
Remote controller
Module identifier (in operator unit CPX-MMI)
Remote I/O
Remote controller
Power supply
Operating voltage/load voltage
Intrinsic current consumption at 24 V
from operating voltage supply for
electronics/sensors (U
Galvanic isolation
between bus interface and CPX periphery (power
supplies)
Mains buffering time
Network-specific characteristics
Network protocol
Specification
Transmission rate
Input/output size
Crossover detection
64
)
EL/SEN
è CPX system description (P.BE-CPX-SYS-...)
IP65/IP67
through the use of PELV circuits
(Protected Extra Low Voltage)
224 (sub-module code 3)
171 (sub-module code 3)
FB39-RIO
FB39-RC
è CPX system description (P.BE-CPX-SYS-...)
typ. 100 mA (internal electronics)
Yes
at least 25 ms
Sercos III
Standards/norms with reference to Sercos III:
– IEEE 802.3
– IP-based protocols (UDP, TCP, ICMP, ...)
100 Mbit/s full duplex
64 byte/64 byte (operating-mode-independent)
Auto-MDI/MDI-X
Festo – P.BE-CPX-FB39-EN – 1504NH – English