Applicability Of The Manual - RMG TME400-VMF Operating Manual

Danger
In addition, the following applies for work in hazardous areas (all zones):
Only trained and instructed personnel are permitted. Work on the
-
measuring system must only be carried out from qualified persons and
inspected by responsible qualified supervisors.
Qualified persons have been authorized by the person responsible for
-
safety of personnel to carrying out such work on the basis of their
training, experience or instruction and familiarity with applicable
standards, provisions, accident prevention regulations and system
conditions. It is essential that these persons are able to recognize and
avoid potential dangers in good time.

Applicability of the manual

1.2.6.
This manual describes the TME400. TME400 is generally only part of a complete
system. The manuals of the other components of the system must be observed. If
you find contradictory instructions, contact RMG and/or the manufacturers of the oth-
er components.
Note
Ensure that the power data of the current connection matches the specifica-
tions on the type plate. Ensure that the limit values specified in the conformi-
ty certificate (see appendix) for the devices to be connected are not exceed-
ed.
Observe any applicable national regulations in the country of use. Use cable
that is appropriate for the cable fittings.
Danger
Only work on the equipment if you have the appropriate training and qualifi-
cations.
Attention: Risk of destruction due to body electricity, e.g. due to the rubbing
of clothing.
Manual TME400-VMF · EN02 · 2018 September 6th
1 Introduction
11