Coordinates In Context; Volume / Meters - RMG TME400-VMF Operating Manual

Coordinates in context

4.3.3.
In the following, the coordinates which can be addressed with the TME400-VM and
TME400-VMF turbine meters are shown. In the tables, the parameters which can be
addressed with the TME400-VM are shown in light blue and the values which are
additionally available with the version for custody-transfer applications, TME400-
VMF, are shown in orange.
TME400-VM
TME400-VMF

Volume / Meters

4.3.3.1.
Coor- Name
dinate
A02 Operating volume
A05 Uncorrected operating
volume
A06 Volume Start/Stop
A07 Volume Reset
A10 Meter factor
Non-custody-transfer applica-
tions
Custody-transfer applications
Description
Volumes added up at current (temperature and pressure) conditions.
Z26: If the characteristic correction is deactivated, A05 is not visible
and cannot be adjusted.
If a characteristic correction is activated, this characteristic curve
correction of 0 to this value is deactivated.
Starts and stops a volume flow measurement
Sets the volume flow rate to 0
With the meter factor (pulse value), the corresponding operating
value flow is calculated from the signal frequency of the sensor ele-
ment in the meter electronics.
��
��
The meter factor must be calibrated at the factory so that a direct
meter display in cubic meters.
Note
A change of this adjustment takes place in the responsibil-
ity of the operator.
After any change to the meter factor, calculation takes place
with the new value immediately.
The uninfluenced signal frequency of the sensor element is available
at the HF output. The frequency range can be determined from the
3
�� ��
��
= ∗ 3600[ ]
�� ℎ
��
Manual TME400-VMF · EN02 · 2018 September 6th
4 Operation
55