3 TME400
Caution
It is necessary to remove the seals, particularly the seal over the calibration
button in order to boot up (see Figure 7: Position of the calibration button).
The TME400 must only be used for custody transfer with unbroken seal. Re-
43
moval or damage to seals normally entails considerable expenses!
Re-application of seals must only be carried out by an officially recognized
inspection authority or calibration officials!
Figure 7: Position of the calibration button
Note
The current parameter settings and meter statuses are lost when re-booting!
They are reset to standard values.
Therefore, prior to booting up, read and store all parameters of the TME400.
Manual TME400-VMF · EN02 · 2018 September 6th