RMG TME400-VMF Operating Manual page 69

Z05
X:Y maximum pulse
Z10 Error register 1
Z11 Error register 2
Z12 Status register 1
Z13 Status register 2
Z15 Code word release
Z16 Change code word
Z17 Device type
Z24 Display active max.
Z25 Volume metering mode
Z26 Characteristic correc-
tion
see above
Display value
Display value
Display value
Display value
Note
The code word for the TME400 is:
With entry of this code word, the protected parameters can be
changed.
A new password can be defined here.
0 TME400-VM (default)
1 TME400-VC
2 TME400-VM MID
3 TME400-VC MID
0 1 minute (default)
1 5 minutes
2 60 minute test
The time during which the display is active for tests is selected as
60 minutes. In general, however, it must be observed that higher
energy consumption is associated with this time, so this time should
be selected as short as possible, if possible.
0 1-channel without errors (default)
1 1-channel stop on error
2 1-channel run on error
3 1-channel start / stop
4 1-channel reset
5 2-channel stop on error
6 2-channel run on error
7 2-channel without X:Y error
With 1-channel measurements (0, 1, 2, 3, 4), the Z04 and Z05 pulse
comparison is not activated.
An entry for sensor type 2 is superfluous and has no further signifi-
cance.
If the TME400 is supplied with a current supply, the TME400 ena-
bles a characteristic correction via a polynomial. This correction
must be activated with coordinate Z26. With this polynomial correc-
tion, the corresponding percentage deviations of the turbine meter
1 2 3 4
Manual TME400-VMF · EN02 · 2018 September 6th
4 Operation
63