MacDon M1170 Assembly Instructions Manual page 100

15. Install pin (B) through the header leg (engaging U-
bracket in draper header support) on both sides and
secure with a hairpin (A).
16. Raise header stand (D) to storage position by pulling
spring pin (C) and lifting stand into uppermost position.
Release spring pin.
17. Disengage safety prop by turning lever (A) downward to
raise safety prop until lever locks into vertical position.
NOTE:
If safety prop will not disengage, raise header slightly.
18. Repeat for opposite side.
CAUTION
Check to be sure all bystanders have cleared the area.
19. Start engine and press HEADER DOWN switch (A) on
GSL to fully lower header.
214735
PERFORMING PREDELIVERY CHECKS
90
A
C
B
Figure 4.93: Header Leg
Figure 4.94: Cylinder Safety Prop
A
Figure 4.95: GSL
D
A
Revision A