MacDon M1170 Assembly Instructions Manual page 4

List of Revisions
The following list provides an account of major changes from the previous version of this document.
Summary of Change
Added caution statement: "Engine exhaust gases
become very hot during operation and can burn people
and common materials. Stay clear of the rear machine
and avoid exhaust gases when engine is running."
Added caution statement: "Before disconnecting fuel
lines or any other components under high-pressure
between the fuel pump and high-pressure common rail
fuel system, confirm that the fuel pressure is relieved."
Added topic.
Updated R113 and A40DX tire pressures. Added R116
and A40DX Grass Seed.
Added Warning and Caution statements to beginning of
procedure to ensure engine is off and park brakes are
engaged.
•
Added reference to R1 hydraulic drive bundle
(B6621).
•
Added step to connect knife pressure hose if
switching from a rotary header.
•
Added illustration showing both rotary configuration
and auger/draper configuration.
•
Added step to disconnect knife pressure hose.
•
Added illustration showing both rotary configuration
and auger/draper configuration.
•
Added steps for closing the left platform.
•
Added swath compressor to list of sensors that may
require calibration.
•
Revised note to say a sensor requires calibration if
header or attachment is connected for the first time.
•
Revised note to say the header must be attached
and engaged to calibrate the knife drive.
Updated system capacities:
• DEF – 28 liters (7.5 US gallons)
• Diesel fuel – 518 liters (137 US gallons)
• Hydraulic oil – 60 liters (15.8 US gallons)
• AC refrigerant – 2.38 kg (5.25 lb.)
214735
Location
1.6 Engine Safety, page 11
1.6.1 High-Pressure Rail, page 11
3.10 Replacing Speed Identification Symbol (SIS)
Decal (US Only), page 34
4.1.10 Checking Tire Pressures, page 52
4.1.12 Checking and Adding Wheel Drive Lubricant,
page 59
•
Connecting A40DX Hydraulics, page 82
•
Connecting D1X or D1XL Series Hydraulics, page
92
Connecting R1 Series Hydraulics, page 100
4.7 Calibrating the Windrower and Header, page 108
5.1 Lubricants, Fluids, and System Capacities, page
113
ii
Revision A