MacDon M1170 Assembly Instructions Manual page 40

6. Attach rod ends of anti-shimmy dampeners to arm with
M16 x 90 flange head bolt (A) and three hardened
washers (B).
NOTE:
These washers (B) are stamped with L9 for
identification.
7. Torque bolt (A) to 244 Nm (180 lbf·ft).
8. Install jam nut (C) and torque to 136–140 Nm
(100–103 lbf·ft).
9. Tighten bolts (D) at barrel end of anti-shimmy
dampeners, and torque to 136–140 Nm
(100–103 lbf·ft).
IMPORTANT:
Maintain arm parallel to walking beam while tightening.
Do NOT overtighten.
10. Repeat Steps 2, page 29
of walking beam.
IMPORTANT:
Torque bolts after first 5 hours of operation, and then
again after 10 hours.
214735
ASSEMBLING THE WINDROWER
to 9, page 30 for opposite end
A
Figure 3.30: Anti-Shimmy System – Left Side
30
B
C
D
Revision A