MacDon M1170 Assembly Instructions Manual page 120

10. When Stage 1 of the calibration is complete, press the
PLAY button (A) on the screen to continue with Stage 2
of the calibration process.
11. When Stage 2 of the calibration is complete, press the
RESUME button (A) on the screen to set HEADER
FLOAT, or press the HOME or BACK button (not
shown) to exit without setting the float.
NOTE:
Press the X button (A) on the screen (or press the
HOME, BACK, or any GSL button [buttons not shown])
at any time during the calibration process to EXIT
calibration without saving. The engine speed will return
to the original rpm prior to starting the calibration
process.
NOTE:
If a sensor goes out of its normal operating range during
the calibration process, calibration will stop, and a
message will appear on the screen indicating that the
sensor is out of range. A flashing amber question mark
will appear on the calibration icon in the menu system. If
a sensor is out of range, adjust the sensor and restart
the calibration process.
214735
PERFORMING PREDELIVERY CHECKS
110
Figure 4.142: Calibration Page
Figure 4.143: Calibration Page
Figure 4.144: Calibration Page
A
A
A
Revision A