MacDon M1170 Assembly Instructions Manual page 57

3. Remove the dipstick again and check the oil level. Oil
level should be between LOW (L) and HIGH (H). If
below the LOW mark, add oil.
NOTE:
Adding 1.9 liters (2 US quarts) will raise the level from
LOW to HIGH.
4. Replace dipstick and turn it clockwise to lock.
If oil level is too low, follow these steps to add oil:
1. Move latch (A) towards right cab-forward side of the
windrower.
2. Grasp louver (B), and lift hood to open.
3. Clean around filler cap (A) and remove by turning it
counterclockwise.
4. Carefully add oil to achieve the desired level. A funnel is
recommended to avoid spillage. For oil specifications,
refer to 5.1 Lubricants, Fluids, and System Capacities,
page 113.
CAUTION
Do NOT fill above the HIGH mark.
5. Replace oil filler cap (A) and turn it clockwise until snug.
214735
PERFORMING PREDELIVERY CHECKS
47
Figure 4.6: Engine Oil Level
B
Figure 4.7: Hood
Figure 4.8: Oil Filler Cap
A
A
Revision A