MacDon M1170 Assembly Instructions Manual page 67

9. Turn the IGNITION switch to crank (A).
NOTE:
When the engine starts and the header is not engaged,
the HPT will display the header disengaged screen (B).
IMPORTANT:
•
Do NOT operate starter for longer than 15 seconds
at a time.
•
If engine does not start, wait at least 2 minutes
before trying again.
•
If you crank the engine for more than 30 seconds
within a 2-minute period, the engine will lock the
starter circuit to prevent overheating, and a flashing
WTS symbol will illuminate on the HPT display. Wait
for the WTS symbol to stop flashing before
attempting to crank engine again.
•
If engine still does not start, refer to
Troubleshooting Tips, page
NOTE:
When the engine temperature is below 5°C (40°F), the
engine will cycle through a period where it appears to
labor until the engine warms up. Do NOT operate engine
above 1500 rpm until the HPT engine temperature gauge
is above the blue range (A).
214735
PERFORMING PREDELIVERY CHECKS
Engine Start
58.
57
A
Figure 4.22: HPT Header Disengaged Screen
A
Figure 4.23: HPT No Header Screen
B
1019655
Revision A