MacDon M1170 Assembly Instructions Manual page 48

9. Grasp hood by louver (A) and lower until hood
engages latch.
CAUTION
To avoid injury, keep fingers clear of weight bracket
when installing weights.
10. Install weights (A) from outboard side and slide to
middle of bracket on walking beam.
11. Install retaining bracket (B) on each side of weight
bundle.
IMPORTANT:
Ensure retaining bracket (B) engage slot (C) in bracket.
12. Install rod (D) through retaining bracket and weights
with spacers (E) as required.
13. Secure with nuts (F) and tighten.
IMPORTANT:
Ensure nuts (F) are flush with rod.
214735
ASSEMBLING THE WINDROWER
Figure 3.42: Engine Compartment
Figure 3.43: Weights Installed
Figure 3.44: Base Kit – 163 kg (360 lb.)
38
A
E
B
D
C
E
F
B
C
D
F
E
A
A
E
Revision A