Introduction; Purpose; Overview - Newport SMC100CC Command Interface Manual

SMC100CC & SMC100PP
1.0

Introduction

Single-Axis Motion
Controller/Driver
SMC100CC & SMC100PP
1.1

Purpose

The purpose of this document is to provide the method syntax of each
command to communicate with the SMC100 device exposed in assembly
Newport.SMC100.CommandInterface.dll. This .Net assembly is
designed and developed by Newport. This DLL is used by SMC100
applet to communicate with SMC100 instrument.
1.2

Overview

Typically this DLL exposes all the commands the instrument supports.
These commands are exposed as function calls of the Command Interface
DLL.
Newport.SMC100.CommandInterface.dll is the assembly used for
communicating with SMC100 instrument. This assembly gets installed
when SMC100 applet is installed.
Each function name is defined with the command code "AA".
For each command function, refer to the SMC100 programmer's manual.
NOTE
1
Command Interface Manual
EDH0311En1021 – 09/18