Power Switch; Keyboard And Mouse; Front And Rear Usb Connectors; Ethernet Port - HunterLab EasyMatch User Manual

Note: Use only the power cord included with this instrument or a replacement obtained
from HunterLab. Be certain that the power cord is in good condition before connecting it.

Power Switch

•
To turn the instrument on, press the rocker switch on the back of the instrument.

Keyboard and Mouse

•
The Aeros works with the following keyboard and mouse:
▪
L02-1017-434 Wireless keyboard and mouse kit.
•
To use this accessory, turn the power off. Plug in the micro USB adaptor to the rear of the
instrument and then attach the nano-receiver for the keyboard into the USB port. Install
the batteries into the keyboard/mouse and turn the power back on.

Front and Rear USB Connectors

•
There are two USB connectors on the Aeros. The one in the front is typically used for
exporting jobs and workspaces, backing up the instrument and updating software. The USB
port on the back of the instrument is typically used to connect a printer or a keyboard to the
Aeros.

Ethernet Port

•
This port is used to connect the Aeros to:
▪
Computer or to a network with the purpose of sending data (ASCII) to a server.
▪
Connect with EasyMatch QC and EasyMatch ER Validation and Compliance
▪
Remote Support
▪
Network printer.
8
User's Manual for Aeros and EasyMatch Essentials v 1.1
CAUTION

Figure 3. USB Port on Rear of Instrument

USB Data Port
Ethernet Port