Figure 127. Rear View Of Aeros; Figure 128. Command Prompt Ipconfig; Figure 129. Configuration Parameters For Ethernet - HunterLab EasyMatch User Manual

❖
Plug Ethernet cable into RJ-45 Ethernet connection at rear of Aeros.
❖
Plug the other end into the Computer or into the Ethernet adapter
•
Open Command Prompt in the PC.
Type in ipconfig, find the right ethernet (in this case, it is Ethernet adapter Ethernet) and
write down autoconfiguration IPv4 Address as well as the Subnet Mask.
•
Configure the Aeros
Open Aeros Essentials, go to Workspaces > Preferences > Configure Network Settings. First,
select the Ethernet configuration. Uncheck Use DHCP for Ethernet Config. Type in IP
address and Subnet Mask manually. The IP address here should be same as the
autoconfiguration IPv4 Address in the PC, except changing the last number. The Subnet
Mask is the exact same.
72
User's Manual for Aeros and EasyMatch Essentials v 1.1

Figure 127. Rear View of Aeros

Figure 128. Command Prompt ipconfig

Figure 129. Configuration Parameters for Ethernet

Ethernet Port