Password Information; Error Responses - Extron electronics IN1606 User Manual

Password Information

]
The
Password:
by a carriage return. The prompt is repeated if the correct password is not entered. If the
correct password is entered, the unit responds with
]
Login User
administrator and user, the unit defaults to administrator privileges.

Error Responses

When the scaler receives a valid command, it executes the command and sends a
response to the host device. If the unit is unable to execute the command, it returns an error
response to the host.
Error values
— Invalid input number
E01
— Invalid command
E10
— Invalid preset number
E11
— Invalid port number
E12
— Invalid parameter
E13
— Not valid for this configuration
E14
Error response references
These references in the command and response tables note particular error responses to
that command.
= Commands that give an
14
product whose current configuration does not support the command.
= Commands that give an
24
= Commands that may give an
28
IN1606 and IN1608 Series Scaling Presentation Switcher • SIS Communication and Control
prompt requires a password (administrator level or user level) followed
]
, depending on password entered. If passwords are the same for both
(invalid command for this configuration) error if sent to a
E14
(privilege violation) error if not administrator level.
E24
(file not found) error.
E28
]
Login Administrator
— Invalid command for signal type
E17
— Busy
E22
— Privilege violation
E24
— Device not present
E25
— Maximum number of connections
E26
exceeded
— Bad filename or file not found
E28
]
or
30