Connection Details - Extron electronics NAV SD 511 Setup Manual

Connection Details

LockIt Lacing Brackets
®
Plug the HDMI or USB cable into the panel connection (see
1.
Loosen the connection mounting screw from the panel enough to allow the LockIt lacing bracket to
2.
be placed over it (
2
Place the LockIt lacing bracket on the screw and against the connector (
3.
to secure the bracket.
ATTENTION:
• Do not overtighten the connector mounting screw. The shield it fastens to is very thin
and can easily be stripped.
• Ne serrez pas trop la vis de montage du connecteur. Le blindage auquel elle est
attachée est très fin et peut facilement être dénudé.
Loosely place the included tie wrap around the connector and the LockIt lacing bracket as shown (
4.
While holding the connector securely against the lacing bracket, use pliers to tighten the tie wrap, then remove any excess length (
5.
Analog audio output connector
No Ground Here
Tip
Sleeves
Tip
No Ground Here
Do not tin the wires!
Unbalanced Stereo Output
Control connector
Control Connectors
For information on safety guidelines, regulatory compliances, EMI/EMF compatibility, accessibility, and related topics, see the
Extron Safety and Regulatory Compliance Guide
6
Worldwide Headquarters: Extron USA West, 1025 E. Ball Road, Anaheim, CA 92805, 800.633.9876
). The screw does not have to be removed.
Tip
Ring
Sleeves
Tip
Ring
Balanced Stereo Output
IR Device
Rx Tx
Tx Rx Gnd
RS-232 Device
Remote and Sync Connectors
on the Extron website.
©
2021 Extron — All rights reserved.
All trademarks mentioned are the property of their respective owners.
, at right for an HDMI example).
1
), then tighten the screw
3
EXT connector
Pins:
12345678
Pin
TP Wires
Power connector
Sync Device
S 5V
Smooth
Ridges
SECTION A–A
Tx Rx Gnd
A
Power Supply
RS-232 Device
Output Cord
www.extron.com
3 3 3
1 1 1
3
4 4 4
5 5 5
).
4
TIA/EIA T568B
Wire color
1 White-orange
Orange
2
3 White-green
4 Blue
5 White-blue
Green
6
7 White-brown
8 Brown
Captive
Screw
Connector
3"
16 (5 mm) MAX
A
2 2 2
).
5
68-3606-50 Rev. A
01 21