NEC Express5800/R120h-2M Maintenance Manual page 91

Chapter 2 Useful Features
(c) iSCSI Configuration Menu
When you select System Configuration > BIOS/Platform Configuration (RBSU) > Network Options > iSCSI
Boot Configuration from the System Utilities, the iSCSI Boot Configuration menu appears.
For details about the options, see the table below.
Option
iSCSI Initiator Name
Add an iSCSI Attempt
Delete iSCSI Attempts
iSCSI Attempts
AttemptX
Add an iSCSI Attempt Menu
①.
When you select System Configuration > BIOS/Platform Configuration (RBSU) > Network Options > iSCSI
Boot Configuration > Add an iSCSI Attempt from the System Utilities, the Add an iSCSI Attempt menu
appears.
This menu increases or decreases, depending on the installed status of the network interface card.
For details about the options, see the table below.
Option
(UEFI LAN Driver name)
Example:
SlotX PortY : Intel(R)
Ethernet Controller
i. (UEFI LAN Driver) Menu
When you select System Configuration > BIOS/Platform Configuration (RBSU) > Network Options > iSCSI
Boot Configuration > Add an iSCSI Attempt > (UEFI LAN Driver) from the System Utilities, the (UEFI LAN
Driver) menu appears.
For details about the options, see the table below.
Option
iSCSI Attempt Name
iSCSI Boot Control
IP Addrss Type
Connection Retry Count
Connection Timeout
Initiator DHCP Config
Parameter
String of 4 to 223 alphanumeric
characters
-
-
-
-
Parameter
-
Parameter
[1]
[Disabled]
Enabled
Enabled for MPIO
[IPv4]
IPv6
Auto
0-16
[3]
100-[20000]
(Check Box)
Express5800/R120h-1M, R120h-2M Maintenance Guide
Description
The worldwide unique iSCSI Qualified Name (IQN)
of the iSCSI initiator. Only IQN format is accepted.
EUI format is not supported. For example:
iqn.2001-04.com.example:uefi-13021088
Add an iSCSI Attempt
Deletes one or more iSCSI attempts.
-
-
[
Description
-
Description
A descriptive name for this iSCSI attempt
configuration.
Use this option to set the iSCSI mode for this attempt,
or to enable the Multi-Path I/O (MPIO) capability.
Use this option to configure the iSCSI initiator IP
address type (IPv4 or IPv6). In Auto mode, the iSCSI
connection uses the IPv4 stack, and if the connection
fails, is re-attempted using the IPv6 stack.
The number of times to retry the iSCSI connection.
Valid values are between 0 and 16. A value of 0
means no retries.
The iSCSI connection timeout value in milliseconds.
Valid values are between 100 milliseconds and 20
seconds (20000 milliseconds).(def:1000)
Enables or disables configuring the iSCSI initiator IP
address from DHCP.(def:0)
1. System Utilities
]: Default setting
91