NEC Express5800/R120h-2M Maintenance Manual page 182

Chapter 3 Appendix
Class Error code
UEFI Non-Volatile Variable Store
Corruption Detected. If enabled,
UEFI 268
Secure Boot security settings may be
lost.
IMPORTANT: Default configuration
settings have been restored per user
UEFI 269 request. If Secure Boot was enabled,
related security settings may have been
lost.
%1 FW Communication Issue - Unable
to communicate with %2 FW. Certain
UEFI 270
management functionality is not
available.
Processor %1, DIMM %2 could not be
authenticated as genuine %3.
UEFI 271
Enhanced and extended %4 features
will not be active.
IMPORTANT: Processor %1,
UEFI 272 DIMM %2 may not be a Genuine %3
DIMM.
Option Card Configuration Error. An
UEFI 276 option card is requesting more memory
mapped I/O than is available.
Secure Boot Authentication Failure -
UEFI 277 The image on %1 failed authentication
and was not executed.
Secure Boot Authentication Failure -
The image on %1 was not authorized
UEFI 278
due to revoked certificate(s) and was
not executed.
IMPORTANT: SW12 is ON indicating
physical presence. This switch should
UEFI 281
only be ON to override certain security
protections.
Invalid Server Serial Number and
UEFI 282 Product ID - The Serial Number and/or
Product ID have been corrupted or lost.
DIMM Failure - Uncorrectable Memory
UEFI 284
Error - Processor %1 Dimm %2
182
Error message
Express5800/R120h-1M, R120h-2M Maintenance Guide
Action
The system configuration has been initialized to
default. Make the necessary settings in the system
utility. If the problem persists, contact your sales
representative.
The system configuration has been initialized to
default. Make the necessary settings in the system
utility. If the problem persists, contact your sales
representative.
Turn off the unit, disconnect the power cord, wait
30 seconds, and then restart it.
If the problem persists, contact your sales
representative.
The DIMM failed to be authenticated as an
authorized part. Check the DIMM connected to the
unit. If the problem persists, contact your sales
representative.
The DIMM failed to be authenticated as an
authorized part. Check the DIMM connected to the
unit. If the problem persists, contact your sales
representative.
The memory space for the optional card failed to be
allocated. Remove the added optional card so that
the system can be booted. If the problem persists,
contact your sales representative.
If the error occurs due to adding of the optional
card, check whether the added card supports the
secure boot. If the problem persists, contact your
sales representative.
If the error occurs due to adding an optional card,
make sure whether the added card meets the
conditions required for secure boot. If the problem
persists, contact your sales representative.
Set the maintenance switch SW12 to OFF unless
the setting is specified in the operating procedure
etc.
When operating the maintenance switch, follow the
procedure in Chapter 1 (7. Resetting and Clearing
the Server) in this manual.
If the problem persists, contact your sales
representative.
The serial number and product ID for identifying
the unit are not correctly set. Contact your
maintenance service company.
Contact your sales representative.
1. IML Error Message