NEC Express5800/R120h-2M Maintenance Manual page 184

Chapter 3 Appendix
Class Error code
%1 Dual microSD Device Unsupported
UEFI 321 Configuration - A microSD card is not
installed in Slot %2
%1 Dual microSD Device Unsupported
UEFI 322 Configuration - No microSD cards are
installed.
%1 Dual microSD Device Error - The
UEFI 323
microSD card in Slot %2 has failed.
%1 Dual microSD Device Error - Both
UEFI 324
microSD cards have failed.
%1 Dual microSD Device Error -
UEFI 325 microSD cards have conflicting
metadata. Configuration required.
%1 Dual microSD Device Error - The
UEFI 326 microSD card in Slot %2 has failed. A
microSD card is not installed in Slot %3.
AMP Configuration Error - An installed
processor does NOT support the
UEFI 327
configured AMP Mode. System will
operate in Advanced ECC Mode.
Power Management Controller
UEFI 328 Firmware Error - The firmware is in
Recovery Mode.
Power Management Controller FW
UEFI 329 Error - Unable to communicate with the
FW.
%1 RESTful API Error - Unable to
communicate with iLO FW. BIOS
UEFI 333
configuration resources may not be
up-to-date.
184
Error message
Express5800/R120h-1M, R120h-2M Maintenance Guide
Action
Make sure whether the corresponding microSD
card is correctly mounted. If the problem persists,
contact your sales representative.
Make sure whether the corresponding microSD
card is correctly mounted. If the problem persists,
contact your sales representative.
Contact your sales representative.
Contact your sales representative.
Use the system utility to set up the primary
microSD card. If the problem persists, contact your
sales representative.
Contact your sales representative.
Contact your sales representative.
Update the firmware of the power management
controller. If the problem persists, contact your
sales representative.
Please take actions in the following order.
1. Turn off the unit, disconnect the power cord,
wait 30 seconds, and then restart it.
2. If the problem persists, contact your sales
representative.
Please take actions in the following order.
1. Reset the iLO following the procedure of Chapter
1 (7. Resetting and Clearing the Server) in this
manual. Also, restart the unit.
2. If the problem persists, turn off the power of the
unit, disconnect the power cord, wait 30 seconds,
and then restart it.
3. If the problem persists, contact your sales
representative.
1. IML Error Message