NEC Express5800/R120h-2M Maintenance Manual page 195

Chapter 3 Appendix
Class Error code
The installed number of DIMMs on one or
more processors results in an unbalanced
UEFI 510 memory configuration across memory
controllers. This may result in non-optimal
memory performance.
One or more DIMMs have been mapped
out due to a memory error, resulting in an
UEFI 511 unbalanced memory configuration across
memory controllers. This may result in
non-optimal memory performance.
UEFI 530 Core Boost Technology Disabled.
Unsupported Power Supply
UEFI 1626 Configuration - Unsupported Power
Supply detected.
UEFI 1636 %1 Trusted Platform Module Error.
Slot %1 Encryption Failure -
Communication issue prevents drive
UEFI 1809 keys from being retrieved. Encrypted
logical drives are offline. System may
not boot.
Slot %1 Encryption Failure - Master Key
is incorrect on or not retrieved from
UEFI 1810 Remote Key Manager. Encrypted logical
drives may be offline. System may not
boot.
Slot %1 Encryption Failure - Drive Keys
not retrieved from the Remote Key
UEFI 1811 Manager. Dependent encrypted logical
drives are offline. System may not
boot.
Slot %1 Encryption Failure - Invalid
Drive Keys on Remote Key Manager.
UEFI 1812
Encrypted logical drives may be offline.
System may not boot.
Slot %1 Encryption Failure -
Communication issue prevents keys
UEFI 1814 from being retrieved. Dependent
encrypted logical drives are offline.
System may not boot.
Slot %1 Encryption Failure - Imported
encrypted logical drives are offline.
UEFI 1822
Matching Local Master Key required.
System may not boot.
Error message
Express5800/R120h-1M, R120h-2M Maintenance Guide
Action
Referring to the user's guide, change the mounting
positions or number of DIMM.
In case a problem is not resolved, contact your sales
representative.
Contact your sales representative.
System Configuration > BIOS/Platform Configuration
(RBSU) > Power and Performance Option -> From
[Advanced Performance Tuning Options], set the [Core
Boosting] option to [Enabled].
If the problem persists, contact your sales
representative.
Contact your sales representative.
Contact your sales representative.
The motherboard and the TPM module must be
replaced as a set.
Refer to the page of the iLO key manager to check
the corrective action.
Correct the problem with the Key Manager.
Correct the problem with the Key Manager.
Restore the correct version of the drive key with
the Key Manager.
After turning off the server power and
disconnecting the power cord, check the
installation of the Slot% 1 controller (card). Wait 30
seconds, and then restart it. If the problem
persists, contact your sales representative.
Enter the local master key using the Smart Storage
Administrator.
1. IML Error Message
195