Preface - Siemens SIDOOR AT40 System Manual

Preface

Content of the System Manual
This system manual describes:
● The AT40 CAN, AT40 RELAY, AT40 BASIC and ATD400V RELAY controllers are
automatic door controllers for use in elevators.
● Geared motors, power supplies, additional units that you can use with the control units.
Target group
The System Manual is intended for fitters, commissioning technicians, owner-operators,
service engineers and project engineers of elevator door systems.
Firmware versions
This System Manual applies to SIDOOR AT40 as of firmware version V01.44 and SIDOOR
ATD400V as of firmware version V01.06.
Note
You will find the current firmware versions for the controllers SIDOOR AT40 CAN, AT40
RELAY, AT40 BASIC and ATD400V RELAY in the Industry Online Support
(https://support.industry.siemens.com/cs/ww/en/ps/18269/dl).
Figures
The illustrations in this system manual show the SIDOOR User Software Version 1.2 and the
SIDOOR command device. The illustrations for other versions may differ slightly.
Information on the Internet
You can find more information about SIDOOR door drives and their application on the
Internet (https://www.siemens.com/sidoor).
Parameter documentation
Record the determined, optimal parameter settings in the configuration protocol (see
appendix "Configuration protocol (Page 147)"). Have this record to hand when you call the
Hotline.
Door control units SIDOOR AT40 and ATD400V for elevators
System Manual, 06/2018, A5E42192709-AC
3