Learn Run Button - Siemens SIDOOR AT40 System Manual

Starting a learn run via the learn run button
You can start a learn run by pressing the learn run button (S401). Proceed as described in
the section Learn run button (Page 21).
Querying determined values
The determined values for the effective weight and the door width can be queried via the
terminal module as well as via the SIDOOR SOFTWARE KIT and SIDOOR SERVICE
TOOL.
See also
Operating state display (Page 134)
3.1.2

Learn run button

Learn run button
You can start a learn run with the learn run button (S401).
Note
Two types of learn run can be performed. See section Learn run (Page 20).
Learn run with standard parameters:
With the following display, a learn run is to be started via the service menu "
Start learn run with standard parameters
7-segment display
"_"
"5"
"P"
Maximum door width:
The direction of travel, the door width and the moved mass are determined during the learn
run.
The maximum door width must be within the range of 30 cm to 5 m.
The maximum moved mass depends on the motor used.
Note
If a DCP sensor is used, the position of the DCP sensor is determined during the learn run.
If the DCP sensor position is changed, a new learn run must be performed.
Door control units SIDOOR AT40 and ATD400V for elevators
System Manual, 06/2018, A5E42192709-AC
":
Description
No motor has yet been learned. Learn run required.
New motor type detected.
Learn run canceled.
SIDOOR functions
3.1 Basic functions
General setup >
21