Operator Panel; Service Buttons - Siemens SIDOOR AT40 System Manual

4.7.1

Operator panel

Overview
SIDOOR AT40 / ATD400V
①
②
③
④
Figure 4-4
4.7.1.1

Service buttons

"H401" 7-segment display
You can see the operating states as well as the status and error display on the
"H401" 7-segment display. You can find the description of the 7-segment display in the
section Operating state display (Page 134).
Service buttons OPEN and CLOSE
Door movements in the OPEN and CLOSE directions can also be made manually with the
service buttons S402 (OPEN) and S403 (CLOSE).
The service buttons are located parallel to the OPEN and CLOSE signals, which are output
at X6. Each of these service buttons has to be pushed continuously to reach the limit
position of the door, because the door stops when the button is released.
If the OPEN and CLOSE buttons are pressed simultaneously or the OPEN and CLOSE
signals are present simultaneously, the door always moves in the OPEN direction.
Note
Operation with the SIDOOR SERVICE TOOL or the SIDOOR USER SOFTWARE
The doors can also be controlled with the SIDOOR SERVICE TOOL or the SIDOOR USER
SOFTWARE. In this case, the external input signals are disabled in some menus. Additional
information is available in the section SIDOOR SERVICE TOOL (Page 115) and in the
SIDOOR SOFTWARE KIT Operating Instructions
(http://support.automation.siemens.com/WW/view/en/92711247).
Door control units SIDOOR AT40 and ATD400V for elevators
System Manual, 06/2018, A5E42192709-AC
7-segment display
Learn run button
Service button OPEN
Service button CLOSE
Overview of operator panel
4.7 Operating and parameterizing controllers
Controllers
69