Operating Data - Siemens SIDOOR AT40 System Manual

SIDOOR functions
3.3 Extended functions
3.3.2.1

Operating data

Based on the operating data, the service life and frequency of use of the engine and the door
control unit can be determined and evaluated for maintenance purposes.
The operating data can be deleted via the operating menu (see "Service->Maintenance data-
>Delete operating data").
Note
The operating hours counter cannot be deleted.
The following operating data are determined:
● Number of openings
● Number of obstructions
● Number of learn runs
● Number of power failures
● Number of operating hours
● Total electrical energy of the motor (only available as of FW version AT40 V01.46 and
ATD400V V01.07)
● Total electrical energy of the motor (only available as of FW version AT40 V01.46 and
ATD400V V01.07)
Number of openings
The counter is incremented when an opening movement is started from the closed position.
The counter reading is stored retentively.
Number of obstructions
The counter is incremented when the door moves against an obstacle in closing direction.
The counter reading is stored retentively.
Number of learn runs
The counter is incremented when a learn run has been successfully completed. The counter
reading is stored retentively.
Number of power failures
The counter is incremented with a valid parameter set after a restart of the controller. The
counter reading is stored retentively.
36
Door control units SIDOOR AT40 and ATD400V for elevators
System Manual, 06/2018, A5E42192709-AC