Minimal Editor - Siemens SIDOOR AT40 System Manual

Controllers
4.7 Operating and parameterizing controllers
4.7.1.2

Minimal editor

Using the minimal editor
The SIDOOR AT40 and ATD400V control devices have a minimal editor.
The minimal editor is a utility for changing parameters at a control device when the terminal
module, the SIDOOR SERVICE TOOL or the SIDOOR USER SOFTWARE is not available.
In this case, the learn run button (S401) and the two service buttons (S402, S403) are
assigned second functions. The LED display (H401) is used to visualize messages.
You can use the minimal editor to perform the following settings:
● Select a fixed profile
● Set the closing forces (input of the counterweight)
Risk of injury due to moving mechanical parts
Selecting a profile overwrites the specification of the counterweight.
For this reason, set the value for the counterweight (parameter "A") last.
The minimal editor can only be activated by pressing the service buttons S402 and S403 at
the same time as the network is reset.
Activating the minimal editor
1. Disconnect the control device from the power supply by pulling the power plug.
The line voltage can alternatively be connected and disconnected with the X3 connector
directly on the control device.
2. Press and hold down the S402 and S403 buttons simultaneously and reestablish the line
voltage by plugging the power plug back in. Continue to hold down both buttons.
3. An "8" appears on the LED display for approximately 5 seconds as confirmation.
4. Once the display stops, let go of both buttons within approximately 3 seconds. Do not
operate these two buttons until the end of this time window.
5. To confirm the successful activation of the minimal editor, the LED display alternates
between a "C" and the currently assigned profile in the form of a number from 1 to 6.
70
WARNING
Door control units SIDOOR AT40 and ATD400V for elevators
System Manual, 06/2018, A5E42192709-AC