Network Modules; 10-G Network Module - Cisco Firepower 9300 Hardware Installation Manual

Network Modules

Network Modules
The Firepower 9300 contains two network module slots that provide optical or electrical network interfaces.
Network modules are optional, removable I/O modules that provide either additional ports or different interface
types (1/10/40/100 G).
The Firepower network modules plug into the chassis on the front panel. You can also remove the divider
between the two network module slots and insert a double-wide network module.
For More Information

10-G Network Module

The following figure shows the front panel of the 10-G network module (FPR9K-NM-8X10G). The
FPR9K-NM-8X10G is a single-wide module that supports hot swapping. The eight ports are numbered from
top to bottom, left to right.
Note The FPR9K-NM-8X10G is NEBS-compliant.
Note
You can fit four copper SFPs in either the top row of ports or the bottom row of ports. Both rows cannot be
populated at the same time, because of the port row spacing.
Cisco Firepower 9300 Hardware Installation Guide
14
• See 10-G Network Module , on page 14
• See 40-G Network Module , on page 15
• See 100-G Network Module (Two Ports Single Wide), on page 16
two-port single-wide network module.
• See 100-G Network Module (Four Ports Single Wide), on page 17
• See 100-G Network Module (Double Wide) , on page 18
network module.
• See Supported SFP/SFP+ and QSFP Transceivers, on page 26
• See Remove and Replace the Single-Wide Network Module, on page 63
removing and replacing single-wide network modules.
• See Remove and Replace the Double-Wide Network Module, on page 66
removing and replacing double-wide network modules.
for a description of the 10-G network module.
for a description of the 40-G network module.
for a description of the 100-G
for a description of the 100-G double-wide
for a list of supported SFPs.
Overview
for the procedure for
for the procedure for