Stopping Engine; Check After Finishing Work - Komatsu PW160-7H Operation & Maintenance Manual

OPERATION

STOPPING ENGINE

NOTICE
If the engine is abruptly stopped before it has cooled
down, engine Iife may be greatly shortened. Consequently,
do not abruptly stop the engine apart from an emergency.
In particular, if the engine has overheated, do not abruptly
stop it but run it at medium speed to allow it to cool gradu-
ally, then stop it.
1. Run the engine at low idling speed for about 5 minutes to
allow it to gradually cool down.
2. Turn the key in starting switch (8) to the OFF position and
stop the engine.
3. Remove the key from starting switch (8).

CHECK AFTER FINISHING WORK

1. Check the engine water temperature, engine oil pressure and
fuel level on the monitor.
2. Walk around the machine and check the work equipment, and
undercarriage, and check also for leakage of oil or water. If
any abnormalities are found, repair them.
3. Fill the fuel tank.
4. Check the engine compartment for paper and debris. Clean
out any paper and debris to avoid a fire hazard.
5. Remove any mud stuck to the undercarriage.
REMARK
It is normal for water to drip from aircon drain hoses.
PW160-7H VEAM390100
OPERATIONS AND CHECKS BEFORE STARTING ENGINE
8
Heat
Heat
Off
Off
On
On
Start
Start
8
189