HP HPE iLO 5 User Manual page 278

For example:
esxcli system snmp set -e 1 -c public -t <trap dest IP address>@162/public
2. Enter the following command to verify that SNMP is enabled:
esxcli system snmp get
3. Enter the following command to enable and start SMA:
esxcli sma enable
4. Enter the following command to verify that SMA is running:
esxcli sma status
5. Verify that the SMA process (smad_rev) is running.
Disabling the System Management Assistant (VMware)
Procedure
Run the following command: esxcli sma disable.
Using the System Management Assistant for Linux
Prerequisites
• AMS is installed.
• The host SNMP service is configured.
• The network is configured to pass SNMP packets between the host and the SNMP clients.
Procedure
1. Configure the host to support AgentX subagents by adding the following line as the first noncomment
line in the /etc/snmp/snmpd.conf file:
master agentx
2. Enable the System Management Assistant.
• SuSE Linux Enterprise Server 12 and Red Hat Enterprise Linux 7—Enter the following
command: systemctl enable smad_rev; systemctl start smad_rev.
• SuSE Linux Enterprise Server 11 and Red Hat Enterprise Linux 6—Enter the following
command: service smad_rev start.
• Ubuntu 14—Enter the following command: sudo systemctl enable smad_rev; sudo
systemctl start smad_rev.
• Ubuntu 12—Enter the following command: sudo service smad_rev start.
3. Enable and start the Agentless Management Service.
278 Disabling the System Management Assistant (VMware)