HP HPE iLO 5 User Manual page 288

Trap
Trap name
number
9013 cpqSm2SecurityOverrideDisengaged
9017 cpqSm2ServerPowerOn
9018 cpqSm2ServerPowerOff
9019 cpqSm2ServerPowerOnFailure
9020 cpqSm2IrsCommFailure
9021 cpqSm2FirmwareValidationScanFailed
9022 cpqSm2FirmwareValidationScanErrorRepaired
9023 cpqSm2FirmwareValidationAutoRepairFailed
11003 cpqHo2GenericTrap
11018 cpqHo2PowerThresholdTrap
11020 cpqHoMibHealthStatusArrayChangeTrap
5022 cpqSasPhyDrvStatusChange
14004 cpqIdeAtaDiskStatusChange
16028 cpqFca3HostCntlrStatusChange
18011 cpqNic3ConnectivityRestored
18012 cpqNic3ConnectivityLost
288 Configuring iLO management settings
Description
iLO 5 detected that the security
override jumper has been toggled to
the disengaged position.
The server has been powered on.
The server has been powered off.
A request was made to power on the
server, but the server could not be
powered on because of a failure
condition.
Communication with Insight Remote
Support or Insight Online has failed.
Firmware validation failure (iLO/ IE/
SPS firmware).
A reported firmware integrity scan
issue was repaired.
Firmware recovery failed.
Generic trap. Verifies that the SNMP
configuration, client SNMP console,
and network are operating correctly.
You can use the iLO web interface to
generate this alert to verify receipt of
the alert on the SNMP console.
A power threshold has been exceeded.
A change in the health status of the
server has occurred.
AMS detected a change in the status of
an SAS or SATA physical drive.
AMS detected a change in the status of
an ATA disk drive.
AMS detected a change in the status of
a Fibre Channel host controller.
Connectivity was restored to a logical
network adapter.
The status of a logical network adapter
changed to Failed.
Table Continued