Ipv4 Settings - HP HPE iLO 5 User Manual

8. To save the changes you made on the IPv4 Settings page, click Apply.
9. If you are finished configuring the iLO network settings on the General, IPv4, IPv6, and SNTP tabs,
click Reset to restart iLO.
It might take several minutes before you can re-establish a connection.

IPv4 settings

DHCPv4 Configuration settings
Enable DHCPv4
Enables iLO to obtain its IP address (and many other settings) from a DHCP server.
Use DHCPv4 Supplied Gateway
Specifies whether iLO uses the DHCP server-supplied gateway. If DHCP is not used, enter a gateway
address in the Gateway IPv4 Address box.
Use DHCPv4 Supplied Static Routes
Specifies whether iLO uses the DHCP server-supplied static routes. If not, enter the static route
destination, mask, and gateway addresses in the Static Route #1 Setting, Static Route #2 Setting,
and Static Route #3 Setting boxes.
Use DHCPv4 Supplied Domain Name
Specifies whether iLO uses the DHCP server-supplied domain name. If DHCP is not used, enter a
domain name in the Domain Name box on the Network General Settings page.
Use DHCPv4 Supplied DNS Servers
Specifies whether iLO uses the DHCP server-supplied DNS server list. If not, enter the DNS server
addresses in the Primary DNS Server, Secondary DNS Server, and Tertiary DNS Server boxes.
Use DHCPv4 Supplied Time Settings
Specifies whether iLO uses the DHCPv4-supplied NTP service locations.
Use DHCPv4 Supplied WINS Servers
Specifies whether iLO uses the DHCP server-supplied WINS server list. If not, enter the WINS server
addresses in the Primary WINS Server and Secondary WINS Server boxes.
Static IPv4 Address Configuration settings
IPv4 Address
The iLO IP address. If DHCP is used, the iLO IP address is supplied automatically. If DHCP is not
used, enter a static IP address.
Subnet Mask
The subnet mask of the iLO IP network. If DHCP is used, the subnet mask is supplied automatically. If
DHCP is not used, enter a subnet mask for the network.
Gateway IPv4 Address
The iLO gateway IP address. If DHCP is used, the iLO gateway IP address is supplied automatically.
If DHCP is not used, enter the iLO gateway IP address.
172 IPv4 settings