Replacing The Active System Rom With The Redundant System Rom; Ilo Repository; Adding A Component To The Ilo Repository - HP HPE iLO 5 User Manual

• Power Supply firmware
• Embedded Video Controller
Firmware details
The Installed Firmware page displays the following information for each listed firmware type:
• Firmware Name—The name of the firmware.
• Firmware Version—The version of the firmware.
• Location—The location of the component that uses the listed firmware.

Replacing the active system ROM with the redundant system ROM

Prerequisites
• The server supports redundant system ROM.
• Virtual Power and Reset privilege
Procedure
1. Click Firmware & OS Software in the navigation tree.
2. On the Installed Firmware page, click the swap icon
iLO prompts you to confirm the request.
3. Click OK.
The change will take effect after the next server reboot.

iLO Repository

The iLO Repository is a secure storage area in the nonvolatile flash memory embedded on the system
board. This flash memory is called the iLO NAND. Use SUM or iLO to manage signed software and
firmware components in the iLO Repository.
iLO, the UEFI BIOS, SUM, and other client software can retrieve these components and apply them to
supported servers. Use SUM to organize the stored components into install sets and SUM or iLO to
manage the installation queue.
To learn more about how iLO, SUM, and the BIOS work together to manage software and firmware, see
the SUM documentation.

Adding a component to the iLO Repository

Prerequisites
Configure iLO Settings privilege
Procedure
1. Click Firmware & OS Software in the navigation tree, and then click Upload to iLO Repository.
74 Firmware details
next to the Redundant System ROM details.