Setting Section And Trimming Thickness - Thermo Scientific Microm HM355S Operation Manual

Operating Instructions
Display and Key Functions
Setting Section and
Trimming Thickness
28 Operation Manual HM335S
The required section and trimming thicknesses are set with the knob [A].
• To choose between section thickness and trimming thickness, press
the knob [A]
In the NORMAL display mode the thickness range is indicated in the
display.
Note!
When switching over from trim sectioning to fine sectioning by using knob
[A], the motorized cutting speed can be reduced. (see part "setting cutting
speed" page 39)
FEED pre-selected section thickness
TRIM pre-selected trimming thickness
The graduation of the section thicknesses is divided into five ranges:
range
up to 5 µm
from 5 µm to 20 µm
from 20 µm to 30 µm
from 30 µm to 60 µm
from 60 µm to 100 µm
The graduation of the trimming thicknesses is divided into four ranges:
range
up to 30 µm
from 30 µm to 100 µm
from 100 µm to 200 µm
from 200 µm to 500 µm
graduation
0,5 µm
1 µm
2 µm
5 µm
10 µm
graduation
5 µm
10 µm
20 µm
50 µm
Thermo Fisher Scientific